MEDIUM
Earn 100

Explain modes of vibration in carbon dioxide.

Important Questions on Measurement and Data Processing

EASY
A metallic rod breaks when strain produced is 0.2%. Young's modulus of the material of the rod is 7×109 N m-2. What should be its area of cross-section to support a load of 104 N?
EASY
A metal rod of cross-sectional area 3×10-6 m2 is suspended vertically from one end has a length 0.4 m at 100 °C. Now the rod is cooled upto 0 °C, but prevented from contracting by attaching a mass m at the lower end. The value of m is (Y=1011 N m-2, coefficient of linear expansion =10-5 K-1, g=10 m s-2)
MEDIUM

Write copper, steel, glass and rubber in order of increasing coefficient of elasticity.

MEDIUM
Which of the following options possess compounds with the same general formula?
MEDIUM
The load versus elongation graph for four wires of the same material is shown in figure. The thinnest wire is represent by the line -

Question Image
HARD

According to Hooke's law of elasticity, if stress is increased, then the ratio of stress to strain

HARD
A 20 cm long rubber string obeys Hooks law. Initially when it is stretched to make its total length of 24 cm, the lowest frequency of resonance is υ0 . It is further stretched to make its total length of 26 cm. The lowest frequency of resonance will now be :
EASY
A wire Y=2×1011 N m-2 has length 1 m and area 1 mm2 . The work required to increase its length by 2 mm is
EASY
The frequency of nuclei relative to the standard in NMR spectrum is called _____.
EASY
The adjacent graph shows the extension Δl of a wire of length l m suspended from the top of a roof at one end and with a load W connected to the other end. If the cross-sectional area of the wire is 10-6 m2, calculate the Young's modulus of the material of the wire -Δl×10-4m


Question Image
MEDIUM

The length of an elastic spring is a metres when a force of 4 N is applied, and b metres when the 5 N force is applied. Then the length of the spring when the 9 N force is applied is

EASY
In infrared (IR) spectroscopy the region 300-1400 cm-1 is called _____ region.
EASY
X-rays are used in determining the molecular structure of crystaline because
EASY
Tetramethyl silane gives only one sharp absorption, which is called as a _____(Peak/frequency).