MEDIUM
JEE Main/Advance
IMPORTANT
Earn 100

If container is accelerated towards right with acceleration a=g. Find pressure at A.

Question Image 

100% studentsanswered this correctly

Important Questions on Mechanical Properties of Fluids

MEDIUM
JEE Main/Advance
IMPORTANT
A wide tank of cross-section area A, containing a liquid to a height H, has an orifice at its base of area A3. The initial acceleration of top surface of liquid is
HARD
JEE Main/Advance
IMPORTANT

It is desired to design an air plane with a "lift" of $1000 \mathrm{~N}$ per square meter of wing area. If the velocity of streamline flow past the lower wing surface is $100 \mathrm{~m} / \mathrm{s}$, then the required velocity over the upper surface is (given density of air is $1.3 \mathrm{~kg} \mathrm{~m}^{-3}$ )

HARD
JEE Main/Advance
IMPORTANT
A large open tank has two holes in the wall. One is a square hole of side L at a depth y from the top and other is a circular hole of radius R at a depth 4y from the top. When tank is completely filled with water, the quantities of water flowing out per second from both holes are same. The R is equal to
HARD
JEE Main/Advance
IMPORTANT

Equal volume of two immiscible liquids of densities ρ and 2ρ are filled in a vessel as shown in figure. Two small holes are punched at depth h2 and 3h2 from the surface of lighter liquid. If v1 and v2 are the velocities of efflux at these two holes, then v1v2 is

Question Image 

HARD
JEE Main/Advance
IMPORTANT
In a large tank of cross-sectional area A, there is a small hole of area 'a' at the bottom. The time taken to emptying the tank from height h1 to h2 is
HARD
JEE Main/Advance
IMPORTANT

Area of orifice is a. Due to ejection of water of density ρ at a constant speed, the equilibrium compression in spring is x. The speed of ejection of water is

Question Image 

EASY
JEE Main/Advance
IMPORTANT
Two water droplets merge with each other to form a large droplet. In this process
HARD
JEE Main/Advance
IMPORTANT
A spherical liquid drop of radius R is divided into eight equal droplets. If surface tension is T, then work done in the process will be