EASY
Earn 100

State Ohm's law. Draw a graph between voltage and current for a metallic conductor.

Important Questions on Electric Current

EASY

Write Ohm's law. Draw a circuit diagram to prove it experimentally in the laboratory.

MEDIUM

In figure R1=10 Ω, R2=40 Ω, R3=30 Ω, R4=20 Ω, R5=60 Ω and a 12 V battery is connected to the arrangement. Calculate:

(a) Total resistance in the circuit.

(b) Total current flowing in the circuit.

Question Image

 

MEDIUM

The potential difference between the two ends of a conductor is V, and the current flowing through the conductor is I. At a constant temperature, which of the following statement is true for the conductor?

EASY

Establish relation between potential difference V and electric current I by plotting graph.

MEDIUM

How is the concept of resistance obtained from Ohm's law?

EASY
Write any two conditions when Ohm's Law fails.
EASY
An electric bulb of resistance 80 Ω draws a current of 0.75 A. Find the line voltage. 
EASY
In one circuit, resistance of wire is 10 Ω. If it is connected with 2.5 V battery, how much electric current will flow through it?
MEDIUM
State Ohm's law and give its experimental verification.
EASY

A V-I graph for a nichrome wire is given below. What do you infer from this graph? Draw a labelled circuit diagram to obtain such a graph.

Question Image

EASY
An unknown circuit draws a current of 2 A from a 12 V battery. Its equivalent resistance is
HARD
State Ohm's law and describe a method to find the resistance of a coil by using a voltmeter and an ammeter. Also draw the circuit diagram.
MEDIUM

A current of 1 A flows when an electric bulb is connected to 220 V mains. What would be the current when the same bulb is connected to a 110 V main?

HARD
An electric bulb is connected to a source of 220 volt and the current flowing through the circuit is 0.5 ampere. What will be the resistance and power of the bulb?
EASY

Following figures shows graph of I-V. Which graph is correct according to Ohm's law?

Question Image

MEDIUM

The values of current (I) flowing through a given resistor of resistance (R), for the corresponding values of potential difference (V) across the resistor, are as given below:

V (volts) 0.5 1.0 1.5 2.0 2.5 3.0 4.0 5.0
A(amperes) 0.1 0.2 0.3 0.4 0.5 0.6 0.8 1.0

Plot a graph between current (I) and potential difference (V) and determine the resistance (R) of the resistor.