EASY
Earn 100

The band gap of the semiconductor GaAs0.6P0.4 is 1.9 eV. If this material is used to make a Light Emitting Diode (LED), the colour of the emerging light will appear

50% studentsanswered this correctly

Important Questions on Semiconductor Devices

EASY

In the given circuit, The current through battery is

Question Image

EASY
The I - V characteristics of an LED is:
EASY

Take the breakdown voltage of the zener diode used in the given circuit as 6 V. For the input voltage shown in the figure below, the time variation of the output voltage is: (Graphs drawn are schematic and not to the scale)

Question Image 

EASY

In case of a p-n junction diode at high value of reverse bias, the current rises sharply. The value of reverse bias is known as

EASY
If in a p-n junction, a square input signal of 10 V is applied as shown, then the output across RL will be

Question Image
EASY

Two p - n photodiodes are fabricated from semiconductors with band gap of 2.8eV and 2.6eV, respectively.

Choose the correct statement from the following.

EASY

Two Zener diodes (A and B) having breakdown voltages of 6 V and  4 V respectively, are connected as shown in the circuit below. The output voltage V0 variation with input voltage linearly increasing with time, is given by (Vinput = 0 V at t = 0)

 

EASY
In a three phase full-wave rectifier of 100 Hz, the ripple frequency is
EASY
In the given circuit the current through zener diode is:
Question Image
EASY
Zener diode is used to regulate the voltage supply because, while using a zener diode
EASY
Zener breakdown occurs in a p-n junction having pand n both:
EASY

A 220 V A.C. supply is connected between points A and B as shown in figure what will be the potential difference V across the capacitor?

Question Image

EASY
In a full-wave rectifier, circuit operating from 60 Hz main frequency, the fundamental frequency in ripple would be,
EASY
For a p-n junction normal diode and a Zener diode, which of the following statements is true?
EASY
A zener breakdown occurs in a zener diode when
EASY
With increasing biasing voltage of a photo diode, the photocurrent magnitude:
EASY
LED is constructed from Ga-As-P semiconducting material. The energy gap of this LED is 1.9 eV. Calculate the wavelength of light emitted and its colour. h=6.63×10-34 J-s and c=3×108 m s-1