MEDIUM
Earn 100

Which of the following can not be a primary standard solution?

50% studentsanswered this correctly

Important Questions on Redox Reactions

EASY
The number of water molecules in 250 m L of water is closest to [Given, density of water is 1.0 g m L-1; Avogadro's number =6.023×1023
MEDIUM
A gas mixture contains 25% He and 75% CH4 by volume at a given temperature and pressure. The percentage by mass of methane in the mixture is approximately ___ .
MEDIUM
Molality m of 18 M H2SO4 is, approximately [d=1.84 g cm-3, Molar mass of H2SO4=98 g mol-1].
HARD
To measure the quantity of MnCl2 dissolved in an aqueous solution, it was completely converted to KMnO4 using the reaction,

MnCl2+K2S2O8+H2OKMnO4+H2SO4+HCl (equation not balanced). Few drops of concentrated HCl were added to this solution and gently warmed. Further, oxalic acid 225 mg) was added in portions till the colour of the permanganate ion disappeared. What is the quantity of MnCl2 (in mg) present in the initial solution? (Atomic weights in g mol-1: Mn=55, Cl=35.5)
MEDIUM
Dissolving 120 g of a compound of (mol. wt. 60) in 1000 g of water gave a solution of density 1.12 g/mL. The molarity of the solution is :
MEDIUM
50mL of 0.5M oxalic acid is needed to neutralize 25mL of sodium hydroxide solution. What is the amount of NaOH in 50mL of the given sodium hydroxide solution?
EASY
While combusting in air, 4 g of H2 gas was completely converted into water. If 36μmole of CO2 from air is dissolved into that water, what is the concentration of CO2 ?
EASY
While titration dilute HCl solution with aqueous NaOH, which of the following will not be required ?
MEDIUM
The mole fraction of a solvent in aqueous solution of a solute is 0.8. The molality (in mol kg-1 ) of the aqueous solution is:
EASY
What would be the molality of 20% (mass/mass) aqueous solution of KI ? (molar mass of KI=166 g mol-1 )
MEDIUM
For standardizing NaOH solution, which of the following is used as a primary standard?
EASY
What is mole fraction of the solute in a 1.00 m aqueous solution?
HARD
In a complexometric titration of metal ion with ligand M (Metal ion)+L(Ligand)C (Complex) end point is estimated spectrophotometrically (through light absorption). If 'M' and 'C' do not absorb light and only 'L' absorbs then the titration plot between absorbed light (A) versus volume of ligand 'L' (V) would look like:
EASY
A solution of sodium sulphate contains 92 g of Na+ ions per kilogram of water. The molality of Na+ ions in that solution in mol kg-1 is:
MEDIUM
An alkali is titrated against acid with methyl orange as an indicator, which of the following is a correct combination?
HARD
0.4 g mixture of NaOH,Na2CO3 and some inert impurities was first titrated with N10HCl using phenolphthalein as an indicator, 17.5 mL of HCl was required at the end point. After this methyl orange was added and titrated. 1.5 mL of same HCl was required for the next end point. The weight percentage of Na2CO3 in the mixture is (Rounded-off to the nearest integer)
MEDIUM
2KMnO4+3H2SO4+5H2O2K2SO4+2MnSO4+8H2O+5O2
Find the nonnality of H2O2 solution, if 20 mL of it is required to react completely with 16 mL of 0.02MKMnO4 solution. ( Molar mass of KMnO4=158 g mol-1)
HARD

5.00 mL of 0.10 M oxalic acid solution taken in a conical flask is titrated against NaOH from a burette using phenolphthalein indicator. The volume of NaOH required for the appearance of permanent faint pink colour is tabulated below for five experiments. The concentration, in molarity, of the NaOH solution is xM.

Exp. No. Vol. of NaOH mL
1 12.5
2 10.5
3 9.0
4 9.0
5 9.0

What is the value of 100x

Round of your answer to the nearest integer.

 

 

EASY
Which of the following is dependent on temperature?
EASY
8 g of NaOH is dissolved in 18g of H2O. Mole fraction of NaOH in solution and molality (in  mol kg-1) of the solution respectively are: